Extra Setting Time (up to 30 minutes) epoxy is a binary or two part adhesive, in a dispenser with twin tubes and twin blue plungers. Allows about 30 minutes to position parts before setting up. Temperature use range is from -65 to 225 degrees Fahrenheit (-54 to 107 degrees Celsius), note this is much better than the standard epoxy.

MATERIALS: Bonds glass, metal, china, wood, leather, fiberglass, ceramics, and most plastics.

CAUTIONS: Irritating to eyes and skin and may cause sensitization by skin contact. Avoid contact with skin and eyes. Use in well ventilated area.

COMPOSITION: Contains epoxy resin and amine hardener.

FIRST AID: For skin contact wash thoroughly with soap and water. In case of contact with eyes, flush with water for 15 minutes. Call a physician. If swallowed do not induce vomiting, call physician immediately.

PREPARATION OF DISPENSER: Remove storage cap which is located in notches in the plungers. Hold dispenser, nozzle end up, for about half a minute to allow entrapped air to reach tips. Keeping nozzle end up, carefully snip off tips at very end of dispenser with scissors or knife. and push plunger slowly to expel entrapped air. Now ready for use.

USE: Surfaces should be clean and dry. Dispense equal parts of resin and hardener by pressing down slowly on plunger and mix thoroughly on non porous surface. Apply to both surfaces to be bonded and hold together with clamp, tape, or weights. Allow setting time of 30 minutes, item can be handled in 7 hours. Full strength is attained after 24 hours. Setting time longer in cold temperatures, shorter in warm temperatures. To reseal pull back plunger slightly, clean tip and place cap over nozzles, which should fit only one way. Store upright with nozzle up.