Seal-All is an all purpose adhesive that comes in a tube and is weather resistant and not affected by gasoline or oil, according to the package. The package indicates that it is used in the home to repair and maintain fabrics, leather, fiberglass, most plastics, luggage, screens, and just about any thing else. It is used for sporting goods to repair golfing equipment, fishing rods, tents, tarpaulins, canoes, boats, waders, hunting boots, etc. It is used for automotive repair and maintenance including seat covers, weather-stripping, floor mats, windshields, gaskets, electrical insulation, and more.

MATERIALS: For use on wood, steel, aluminum, copper; most plastics and rubber; porcelain, glass, and china; vinyl, fiberglass, canvas, and leather.

CAUTIONS: Use only with adequate ventilation. To avoid breathing vapors, open all windows and doors or use other means to ensure fresh air entry during application and drying. Keep away from heat, sparks, and flame. Extinguish all sources of ignition during use and until all vapors are gone. Prevent build-up of vapors by opening all windows and doors to achieve cross ventilation.

Avoid contact with eyes and skin. Wash thoroughly after handling. Vapor harmful, may cause dizziness, headache or nausea. Causes lung irritation and eye, skin, nose, and throat irritation.

COMPOSITION: Contains methyl ethyl ketone.

FIRST AID: If you experience difficulty in breathing, leave the area to obtain fresh air. If continued difficulty is experienced get medical attention immediately. In case of eye contact, flush immediately with plenty of water for 15 minutes and get medical attention. In case of skin contact, wash thoroughly with soap and water. If swallowed, immediately give 1 or 2 glasses of water and call a physician, hospital emergency room or poison control center immediately.

USE: To open break seal with pointer cap; hold tube upright until ready to use. Do not squeeze tube to force opening. Replace cap each time after use. Always test a small area before full use.

To use as a sealant, apply directly to clean, dry surface; hold firmly until product sets. Additional coats may be applied; allow each layer to dry thoroughly. On leading objects under pressure, tape over Seal-All; additional coats may be applied over tape.

Use as a contact adhesive, spread coating on each surface to be joined together. Allow to harden for 5-10 minutes, then press both surfaces together. Seal-All hardens by solvent evaporation and forms an immediate bond that is difficult to reposition after both adhesive coated surfaces are placed in contact and sufficient pressure is exerted to create full contact between both surfaces. Cure time increases with lower temperatures and decreases with higher temperatures.